Service manual
MN-29250 (rev. 1) • carviNg statioNs • iNstallatioN/operatioN/service MaNual - pg. 3
SITE INSTALLATION
INSTALLATION
SITE INSTALLATION
The appliance, complete with unattached items
and accessories, may be delivered in one or
more packages. Check to ensure all accessories
ordered have been received.
The hot carving station is designed to be
mounted directly on top of a Halo Heat Cook
& Hold oven or holding cabinet. The shelf can
also be used as a free-standing unit.
Remove the 1" legs prior to placing the carving
shelf on top of the Halo Heat cook/hold oven or
holding cabinet. Appliance must be installed on
a stable and level surface.
Ensure that the 1” legs are in place prior to
placing the carving shelf on work surface.
Failure to operate without the 1” legs prior to
heating the shelf could result in damage to the
surface on which the shelf is placed, may pose a
potential fire hazard, and nullifies the validity
of the UL listing mark. Appliance must be
installed on a stable and level surface.
install this appliance in any area where
it may be affected by any adverse conditions
such as steam, grease, dripping water, high
temperatures, or any other severely
adverse conditions.
install near a cold air source such
as a freezer, air conditioning vents, or in any
area where outside air fluctuation can affect
performance.
This appliance must be kept free and clear of
any obstructions blocking access for
maintenance or service.
Lift Breath Guard up and slide into place in
brackets found in the front of the appliance.
A number of adjustments are associated with
initial installation and start-up. Installation and
start-up adjustments are the responsibility of the
dealer or user. These adjustments include but
are not limited to leveling, electrical hook-up and
installation of bulbs.
LEVELING
Level the
appliance from
side-to-side and
front-to-back
with the use of a spirit level.
NOTE: Failure to properly level this appliance
can cause improper function.
DANGER
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH,
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
CAUTION
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN
IN OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
CAUTION
TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.
CAUTION
The performance of this unit has
been optimized using the factory
provided bulbs. These bulbs should
be replaced with an exact replacement
or with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb fi lament.