User`s manual

1. This nice blue LCD will indicate the current operation status.LCD display:

2. If you press this key for a few seconds your Transmitter willCH-ON Key:

switch ON and OFF. Once you have switched the unit ON, just press this

key again slightly and you can edit various parameters such as CHANNEL,

GROUP, RF POWER LEVEL and LOCK/UNLOCK. Once you are in the LOCK

position no further operation is allowed and, in a few seconds, the display

will show the current channel selected (0 to 99). Battery level will also be

shown.

3. Once you are in operation mode you can access this key toSELECT key:

edit certain parameters. Press this key for a few seconds and the unit

will enter in the MUTE mode. (In this way, you can tell your Bass Player

what you think about the Sound Engineer without everybody knowing that!).

Press it again for a few seconds and you will unmute the unit.

Mini 4P Connector: This connector is used to connect the unit with the

clip microphones, for example, HM-38 condenser microphone or LM-10

clip microphone.

Pin 2, GND

Pin 4, for Dynamic or Condenser microphone

Charge Jack: With the rechargeable batteries put inside, use the charger

supplied in your system to recharge the batteries.

Battery Compartment: This unit may be powered from one pair dry or

rechargeable batteries, UM3 size AA 1.5V.

Pin 3, Phantom power supply for Condenser microphone

Pin 1, for guitar, bass and keyboards

3.3 MOD-16P, TransmitterBody Pack