Installation manual

13
E1: the water temperature sensor is not working correctly.
E2 : the tube sensor is not working correctly.
E3 : Pool filtration is running but water flow is not sensed. Water
flow sensor is not working correctly or there is a lack of water
flow. Backwash filter and check suction lines (Skimmer(s) &
Main Drain(s) for obstruction.
E4 : Indicates high water pressure. High limit pressure switch has
activated and turned off power supply.
IF THE HEATER STOPS WORKING ONE OF THE FOUR ERRORS WILL BE DISPLAYED
THE FAILURE LIGHT WILL BE ON AND THE RELEVANT CODE WILL START TO FLASH
CONTROL PANEL FUNCTION - ERROR DISPLAY 1-4