User`s manual

Note: You can select as many as bands that you wish to change, once the indicators of selected bands are

all blinking, then you can adjust the gain value of all these selected bands simultaneously via UP/DOWN keys.

when Release Edit Group (see 6.1) is set ON, if you want to modify the others frequency bands, select it, and

adjust the gain value via UP/DOWN keys separately, it doesn't affect the frequency bands, which has been selected

and modified before. On the other hand, if you set Release Edit Group OFF, all the selected frequency bands, which

include the modified and unmodified will be adjusted together at the same time via UP/DOWN keys.

5.6 Demo mode

5.3 Bypass mode

Press BYPASS key to enter bypass mode, the bypass indicator will light up.

Press BYPASS key again to exit bypass mode, the bypass indicator will go out.

Note: In bypass mode, the output signal has not been processed, so this function will be quite useful for you

to compare the processed signal with unprocessed signal.

5.2 Store preset

Press STORE key after you finish the change.

Using UP/DOWN keys to select between preset 30-99 (user preset).

Press STORE again to store the new preset.

If you don't want to save your new preset, press LINK key to exit from this menu.

Note: Factory preset (0-29) can be used normally, temporarily modified, but can't be cancelled, overwritten or permanently

modified. User preset (30-99) can be programmed by users and used to save your own settings.

5.4 Link mode

Press LINK key to enter link mode, the link indicator will light up.

Press LINK key again to exit link mode, the link indicator will go out.

Note: In link mode, these two channels are "linked together", so the changes will be simultaneously applied to

both channels. Also, the LINK key has "Exit" function.

5.5 Select preset fast

Press and hold DOWN key, then press UP key, the current preset will change to 0, the preset will increase 10

with each press of UP key again.

Press and hold UP key, then press DOWN key, the current preset will change to 0, the preset will decrease 10

with each press of DOWN key again.

Release DOWN or UP key, your selected preset will be loaded (for example preset 30), then use UP/DOWN

keys to select the right preset you want (for example preset 32).

Press and hold LINK key, then press UP key, the current preset will be displayed one by one. The bypass

indicator will be ON in demo mode, you can press LINK to exit from demo mode.

6. SYSTEM SETTING6. SYSTEM SETTING

6.1 Setup mode

When power on this unit, the front panel will show DIAGAN2.14 for a few seconds, press STORE key timely before

the show is finished to enter setup mode. It concludes Master Level, Release Edit Group, Audition Auto, Edit Time

Out and Lock Key settings. In setup mode, you can use STORE key to cycle above settings, then use UP or

DOWN key to change the settings.

6.1.1 Release Edit Group (R.)

ON: It allows you to choose as many as frequency bands to modify their gain values simultaneously.

OFF: You can select one frequency band at a time.

5.7 Level Control

Press and hold the key of 80Hz (CH.A), then press BYPASS, isplays while is flashing, it allows you“L R + d “L””

to adjust the level of CH A via UP/DOWN keys, if you want to adjust the level of CH B, please press the key of

32Hz (CH. A), then ill be flashing, it allows you to adjust the level of CH B via UP/DOWN keys. and“R w “L” “R””

will be switched by pressing the key of 32Hz.