Owner`s manual

Rear Panel:
7 Input sockets
These sockets accept the balanced signal from XLR and 1/4" connectors as
well. These Inputs are compatible with low-impedance, unbalanced/balanced,
line-level outputs emanating from such as mixers, synthesizers, drum
machines, direct boxes, crossovers, etc. Electric guitars, microphones,
and other low level/high-impedance output devices require a pre-amp or a
D/I box. The input circuits of your A1000.4 are electronically balanced.
You can connect either symmetrical ("balanced") or unbalanced sources.
3. CONTROL ELEMENTS
SPOTLIGHT
9 LIMITER Switch
The Limiter circuit will prevent the waveforms to be flattered thus preserving
a proper dynamic range and secure signal reproduction that is distortion-
free. The Limiter status can be monitored from the limit led on the front
panel of your A1000.4.
10 AC Input
10
5
8 Output Sockets
Use these Neutrik Speak-on connectors to connect your speakers.
Standard IEC receptacle. Connect your A1000.4 an AC socket with the
supplied power cord. Before powering up your A1000.4 for the first time,
make certain the stated power requirement of the unit matches the voltage
supplied by the AC socket.
If the fuse blows, replaced with a fuse of the correct type only.
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
AC INPUT 190-240V 50Hz
FUSE:T12AL 250VAC
Power Consumotion: 900W
AC INPUT
LIMITER
OFF
ON
CH1
CH2
LIMITER
OFF
ON
CH3
CH4
4 SPEAKERLOAD MIN.
Use only with a 250V fuse
POWER OUTPUT
CH.4CH.3CH.1 CH.2CH.1 CH.2 CH.3 CH.4
INPUT
9
7 8