R LTO OWNER'S MANUAL ELVIS 15.2XL/15.2XLA SPEAKER ENCLOSURES PASSIVE AND ACTIVE MODELS www.altoproaudio.com Version 1.
IMPORTANT SAFETY INSTRUCTION CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN TO REDUCE THE RISK OF ELECTRIC SHOCK PLEASE DO NOT REMOVE THE COVER OR THE BACK PANEL OF THIS EQUIPMENT. THERE ARE NO PARTS NEEDED BY USER INSIDE THE EQUIPMENT. FOR SERVICE, PLEASE CONTACT QUALIFIED SERVICE CENTERS. WARNING To reduce the risk of electric shock and fire, do not expose this equipment to moisture or rain. Dispose of this product should not be placed in municipal waste and should be separate collection. 11.
IN THIS MANUAL: 1. INTRODUCTION..................................................................................1 2. QUICK START - PASSIVE/ACTIVE SPEAKER CABINET ............................2 -. PASSIVE FULL-RANGE Speaker for ELVIS 15.2XL -. Active FULL-RANGE Speaker for ELVIS15.2XLA 3.CONNECTION PLATE .............................................................................9 -. PASSIVE FULL-RANGE Speaker for ELVIS 15.2XL -. Active FULL-RANGE Speaker for ELVIS15.2XLA 4. WIRE CONNECTIONS..............
HOOK 2. QUICK START - PASSIVE SPEAKER CABINET UP Passive, Full-range, two speakers. This is the simplest set-up. You just need a mixer and a stereo amplifier. It is good for small club gigs, disco,etc. Make all initial connections with all the equipment powered off, and ensure that all the main volume controls are turned down completely. 1).
HOOK 2. QUICK START - PASSIVE SPEAKER CABINET UP If you use a powered mixer for the passive speakers, it is no need to use an amplifier. make sure all the main volume controls of your power mixer are turned down completely. 1). Connect one side of the speaker cable to the SPEAKER OUT of your powered mixer and the other side to the Input socket of your Elvis speaker cabinet. 2).
HOOK 2. QUICK START - PASSIVE SPEAKER CABINETS UP Passive, Full-range, four speakers. It is similar to the first set-up but four speakers are connected instead of two. 1).Follow the same steps as described above. 2).Connect the THROUGH socket of the first Elvis cabinet to the INPUT socket of the second Elvis cabinet. NOTE: Every time you connect Elvis cabinets this way your parallel them to the output of the amplifier that will read half of the impedance of one speaker.
HOOK 2. QUICK START - PASSIVE SPEAKER CABINETS UP Passive two subwoofers and two satellite speakers. With this example, the stereo amplifier drives both the subwoofers and the satellites. In this case we do not call them full-range anymore because they receive a signal from the subwoofer that is already xovered at 125 Hz. In this way, the high energetic content of the low frequencies is limited to the subwoofer and the satellite's woofer act like a mid-woofer. 1).
HOOK 2. QUICK START - ACTIVE SPEAKER CABINETS UP Active, Full-range, two speakers. It is similar to the passive example but you do not need a power amplifier in between the mixer and the 2 ELVIS speakers Make all initial connections with all the equipment powered off, and ensure that all the main volume controls are turned down completely. 1).
HOOK 2. QUICK START - ACTIVE SPEAKER CABINETS UP Active, Full-range, multiple speakers. This solution is particularly flexible when you have a large stage and for fixed installations where you want to send the same signal to different zones like in a Bar, Pub, Restaurant, Church, etc. Each ELVIS cabinet has its own volume control so you can adjust different volumes in different zones. 1). Follow the above steps connecting the MAIN OUTPUTS of the mixer to the LINE INPUTS of 2 Elvis active cabinets. 2).
HOOK 2. QUICK START - ACTIVE SPEAKER CABINETS UP Active, two satellite speakers & two subwoofers. In this example, the mixer is connected to the ELVIS subwoofers and then a 125 Hz xovered line signal is sent to the respective satellites. In this way, the high energetic content of the low frequencies is limited to the subwoofer and the satellite' s woofer act like a mid -woofer. As a consequence the satellites built-in amplifier is not stressed by low frequency content. 1).
SP OT L IG 3. CONNECTIONS HT -. PASSIVE FULL-RANGE: ELVIS15.2XL 1). INPUT: Receive the signal coming from an external power amplifier. (SPK +1/-1 connected; +2/-2 not connected). 2). THRU: Direct LINK to connect in parallel a second speaker cabinet (SPK +1/-1 connected; +2/-2 not connected). LTO R ELVIS 15.
SP OT L IG 3. CONNECTIONS HT ACTIVE FULL- RANGE: ELVIS15.2XLA 1). 2). 3). 4). 5). 6). 7). 8). ON-OFF power switch. Input AC power socket with main fuse. VOLUME main power amplifier control. LINE OUT at + 4dB on XLR connector LINE IN at + 4dB on COMBO connector. Ground lift Switch. POWER, green LED, indicate ON status.
HOOK 4. WIRE CONNECTIONS UP -. For Passive Speaker Cabinets Please only use the power connectors to make connections with other signal source equipment for the passive speaker cabinets. The power connector has four terminals: 1+, 1-, 2+, 2-. 1- 2- 1+ 2+ In our cabinets, only 1+/1- are used to connect the Speaker+/Speaker-, and 2+/2are not used. -.
5. TECHNICAL SPECIFICATION Model No. System Type Continuous Power Peak Power Rating Sensitivity (1W, 1m) Frequency Response Impedance Crossover Frequency Protection Low-Frequency High-Frequency Spherical Wave Guide Horn Coverage Connectors (+1/-1) Enclosure ELVIS15.
6. WARRANTY 1. WARRANTY REGISTRATION CARD To obtain Warranty Service, the buyer should first fill out and return the enclosed Warranty Registration Card within 10 days of the Purchase Date. All the information presented in this Warranty Registration Card gives the manufacturer a better understanding of the sales status, so as to provide a more effective and efficient after-sales warranty service.
SEIKAKU TECHNICAL GROUP LIMITED NO. 1, Lane 17, Sec. 2, Han Shi West Road, Taichung 40151, Taiwan http://www.altoproaudio.com Tel: 886-4-22313737 email: alto@altoproaudio.com Fax: 886-4-22346757 All rights reserved to ALTO. All features and content might be changed without prior notice. Any photocopy, translation, or reproduction of part of this manual without written permission is forbidden. Copyright c 2007 Seikaku Group NF02169-1.