User`s manual

10.

Ok, you have got to this point and you are now in the position to successfully operate

your LYNX-MIX USB series. However, we advise you to read the following section carefully

to be the real master of your own mix. Not paying enough attention to the input signal

level, the routing of the signal and the assignment of the signal will result in unwanted

distortion, a corrupted signal or no sound at all. So you should follow this procedure

for every single channel:

1. Turn down all input and output gain controls.

2. Connect phantom powered microphones before switching on the +48 Volt phantom

power switch.

3. Set the output level of your LYNX-MIX USB mixer or the connected power amplifier

at no more than 75%.

5. Position EQ controls on middle position.

6. Position panoramic (PAN/BAL) control on center position.

8. Increase the input gain properly for maintaining the good headroom and ideal dynamic

range.

9. Depending on the actual application, turn slowly the input and output level controls

for obtaining the maximum gain before distortion.

You can connect unbalanced equipment to balanced inputs and outputs. Simply follow

these schematics.

Audio Connections

5. INSTALLATION AND CONNECTION

7. With a pair of headphone or studio monitor speakers are connected, apply a Line Level

input signal so that the PEAK LED does not light up.

Strain Clamp

Sleeve

Tip

Ring

Sleeve=Ground/Screen

Ring=Right Signal

Tip=Left Signal

Use for Headphone

1/4" Stereo (TRS) Jack Plug

Now, set the CONTROL ROOM/PHONES level at no more than 50%. In this way, you

will be able to hear later what you are doing connecting a pair of headphones or a

pair of powered studio monitor speakers.

Now repeat the same sequence for all input channels. The main LED meter could

move up into the red section. In this case you can adjust the overall output level

through the main mix control.