User`s manual

USER’S MANUAL
Kaleido-ALTO/QUAD | 9
Remaining time counter:
The remaining time counter is identified by the hourglass icon: see figure 3.12 below. To set the
“destination” time, click on the time display to access edit mode. Enter the desired time of day;
the seconds are entered first, up to the hours.Click Enter when finished editing. To start the
remaining time counter, click on the double arrow in the lower right corner to access the controls.
Click on the Play button to start the timer. To stop it, click on the Stop button. The Reset button
is not used with this function.
Fig. 3.10 Countdown Timer Fig. 3.11 Count Up Timer Fig. 3.12 Remaining Time Counter
(Controls not shown)
4 Detailing the Features
This section will detail all the parameters of the system, including all video and audio settings.
4.1 System Status
From the toolbar click the K-Alto or K-Quad button and select Status to display the System Status
window. This window includes four tab-selectable panels that give information on the system.
The first panel is the System status, shown on figure below. It contains basic information about your unit.
• The name of the unit, its adress, IP and MAC addresses (some of these settings may be changed
in the Settings menu).
• The Software, firmware and hardware version numbers are indicated. In the event of a system
upgrade, the software and firmware numbers will reflect the change.
• The RS-232, RS-422 A and RS-422 B ports settings are listed. They may be changed in the
Settings menu.
Figure 4.1 System status panel