User`s manual

USER’S MANUAL
10 | Kaleido-ALTO/QUAD
The next panel is the Video status. Listed here are the type and format of all video inputs connected to
the unit, as well as the output settings currently selected. Additionally, when an embedded audio is being
monitored, the corresponding SDI input is highlighted as shown below. On figure 4.2, the panel shows a
MWO-HDM monitoring output mezzanine installed (lower right corner).
Figure 4.2 Video status panel
The Audio status panel shows all the audio that may be connected to the unit, and indicates if an optional
audio card is installed.
• Embedded AES audio signals are listed here for each valid SDI input: there may be up to four
audio groups per input, each consisting of 2 signal pairs (or four signals).
Note: in this panel you may also select which audio signal to monitor by clicking on a pair. The
pair selected is then highlighted and becomes audible.
• Only one of the two audio groups are listed at a time for all the inputs; to view the other audio
groups, click on the button for the other group and they are in their turn listed below.
Figure 4.3 Audio status panel
• If there is an optional audio card installed in the system, the status of the audio signal connected
to the card is also shown on this panel, much the same way as embedded audio. The symbols
are grayed out if no card is installed.
Audio status:
GREEN: On
RED: Silence or Overload
GRAY: Disabled