User`s manual

USER’S MANUAL
12 | Kaleido-ALTO/QUAD
Date/Time is where you set the internal time reference. Start by setting the Time zone that you wish to
use for your reference. Set the date on the calendar by selecting the correct month using the left/right
arrows and clicking on the correct date; set current time using the up arrow/down arrow buttons.
You may choose the Automatically adjust clock for daylight saving to allow the system to add or subtract
an hour when daylight saving applies. Click the Apply button to apply the changes you just made.
Figure 4.7 Date/Time Properties
Audio Settings opens the Audio Settings panel, which allows various audio parameters to be set.
The Audio Meters tab provides the option of setting
the rise time of the audio meters associated with
audio from the audio card. Select either
Instantaneous or 10 ms. Note that the rise time for
Embedded audio is always instantaneous. It also
allows you to select the 0 dBU reference point for
analog monitoring of digital signals. Select either -
24 dBFS = 0 dBU (per SMPTE RP-155) or -18
dBFS = 0 dBU (per EBU RP-68).
Figure 4. 8 Audio meter settings
The Audio Error Config tab allows you to set the
conditions under which an audio error will be
detected for each of the embedded audio channels
entering the Kaleido-ALTO/QUAD. This can be
done individually for each channel (select the
channel by selecting Group 1-2 or 3-4 using the
buttons at the top, and then selecting AES 1 or
AES 2 for one of the 10 inputs using the 40 buttons
below), or for all channels at once (by clicking the
Embedded Gr. Button at the top left).
Figure 4.9 Audio Error Configuration – main panel