User`s manual

USER’S MANUAL
16 | Kaleido-ALTO/QUAD
selected for a communication port, the other protocol is not available on other ports as only one
communication protocol may be used with the Alto/Quad at any time. Communication port parameters are
set according to the selected function; for Andromeda in particular, parameters may be changed manually
if required. See section 7 Andromeda Port Settings.
Figure 4.16 Serial Ports RS-422A and RS-422B configuration panel
Figure 4.17 Serial Ports RS-232 configuration panel
Network Configuration is where the network settings are found. If your LAN network uses the DHCP
protocol to dynamically allocate IP address on startup, check “Obtain an address via DHCP”; otherwise,
you must specify an IP address the usual way, by entering the necessary information manually. Consult
your network administrator if you are not sure about this.
Figure 4.18 Network configuration panel