User`s manual

USER’S MANUAL
24 | Kaleido-ALTO/QUAD
The Andromeda controller may be set to a different BaudRate. In this case, it is possible to change the
default port settings of the Alto/Quad from an .XML configuration file inside the Kaleido-Alto/Quad. This
configuration is not accessible through the menu and must be accessed through an FTP session.
1 - From your computer, open a Command Prompt (DOS command).
The following instructions must be done in the Command Prompt.
2- At the DOS prompt, change the directory to the temporary directory
3- Open an FTP session to the Kaleido-Alto/Quad by typing “ftp <IP Address>” and log in as the "super
user" user by typing “su”. Change the remote directory to Formats and retrieve the system.xml file.
Note: You should keep your ftp session open to put back the file.
4- At this point the file is in your temporary folder. You have to modify the file to meet your needs. Open
the file and modify it; you may use Notepad for this.
You can change the settings for the following: