User`s manual

14
33
Here, you can connect an external footswitch to turn on/off the onboard effect module. It is 1/4" phone jack.
FOOT SW. Jack
4.5 Rear Panel
34
This switch is used to turn the main power ON and OFF.
POWER ON/OFF Switch
35
Use it to connect your PBM8.250/500 to the main AC with the supplied AC cord.
Please check the voltage available in your country and how the voltage for your PBM8.250/500 is configured be-
fore attempting to connect your PBM8.250/500 to the main AC.
AC Inlet with FUSE Holder
36
These jacks are used to connect speakers. They are configured with 4-way speakon connectors and 1/4" phone
jacks. You can determine the signal that is output to these jacks according to the setting of AMPLIFIER MODE
select switch.
Note: In order to avoid damaging your built-in amplifier, please pay more attention to the impedance of speaker.
Lower load impedances are not permitted.
SPEAKERS Jacks
34
35
36
32
This control is used to control the volume of signal sent to main mix bus, which can be varied from - to
+10dB.
effect
DSP TO MAIN Control
OUTPUT 2
1+ 1-
POS NEG
LEFT/MONO MAIN
OUTPUT 2
OUTPUT 1
OUTPUT 2
2+ 2-
POS NEG
RIGHT/MONITOR
OUTPUT 1
1+ 1-
POS NEG
BRIDGE
2+ 1+
POS NEG
BRIDGE MODE
POWER
FUSE
250V T3.15AH
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
WARNING: SHOCK HAZARD - DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
SERIAL
MODEL
STEREO MODE: 250 W @ 4 OHM
190 W @ 8 OHM
(4 OHM MIN. LOAD)
BRIDGE MODE: 500 W @ 8 OHM
(8 OHM MIN. LOAD)
CLASS 2 WIRING MAY BE USED
LTO
R
POWERD MIXER
MODEL: PBM8.250
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
AC INPUT
100 VAC~60HZ
120 VAC~60HZ
230 VAC~50HZ
240 VAC~50HZ
Use only with a 250V fuse
Use only with a 250V fuse
Use only with a 250V fuse