User`s manual

3.1 Please check the AC Voltage available in your country before connecting your PBM8.250 MK II/500 MK II to the
AC socket.
3.2 Be sure that the main power switch is turned off before connecting the Mixer to the AC socket. Also, you should
make sure that all Input and output controls are turned down. This will avoid damages to your speakers and avoid
excessive noise.
3.4 Complete these connections as illustrated.
3.7 Before disconnecting the PBM8.250 MK II/500 MK II always turn-off the Power switch.
3.8 Do not use solvents to clean your PBM8.250 MK II/500 MK II. A dry and clean cloth will be OK.
3.3 Please connect one side of the speaker cable to speakon or phone jacks of your PBM8.250 MK II/500 MK II
and the other side to the input socket of your speaker cabinet; or connect one side to the main output L/R of
your PBM8.250 MK II/500 and other side to the input socket of your active speaker cabinet or other stereo
power amplifier.
3.5 When no external power amplifier or active speaker connected to the main output L/R of your PBM8.250 MK II/
500 MK II, please switch on your PBM8.250 MK II/500 MK II after turning on all external devices; after using, switch
off your PBM8.250 MK II/500 MK II before all external devices.
3.6 When the external power amplifier or active speaker connected to the main output L/R of your PBM8.250 MK II
/500 MK II, please switch on your PBM8.250 MK II/500 MK II before the external power amplifier or active speaker.
After using, switch off your PBM8.250 MK II/500 MK II after the external power amplifier or active speaker.
3. QUICK START
Passive speaker 2
MAIN OUTMONITOR OUT
LEFT RIGHT
HEADPHONE
OUT
Active speaker 2
MAIN OUTMONITOR OUT
LEFT RIGHT
HEADPHONE
OUT
Passive speaker 2
6
OUTPUT 2
1+ 1-
POS NEG
LEFT/MONO MAIN
OUTPUT 2
OUTPUT 1
OUTPUT 2
2+ 2-
POS NEG
RIGHT/MONITOR
OUTPUT 1
1+ 1-
POS NEG
BRIDGE
2+ 1+
POS NEG
BRIDGE MODE
POWER
FUSE
250V T3.15AH
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
WARNING: SHOCK HAZARD - DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
SERIAL
MODEL
STEREO MODE: 250 W @ 4 OHM
190 W @ 8 OHM
(4 OHM MIN. LOAD)
BRIDGE MODE: 500 W @ 8 OHM
(8 OHM MIN. LOAD)
CLASS 2 WIRING MAY BE USED
LTO
R
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
AC INPUT
100 VAC~60HZ
120 VAC~60HZ
230 VAC~50HZ
240 VAC~50HZ
Use only with a 250V fuse
Use only with a 250V fuse
Use only with a 250V fuse
POWERED MIXER
MODEL:
PBM8.250
MK