User`s manual

LTO

Installation Instructions

REM

The terminal marked REM (remote) accepts a +12V switched input from the source unit (CD player). When the source

unit is switched on, a pulse is sent down this line. The UCS PRO senses this pulse and switches itself on. Your source

unit should be equipped with a suitable Remote Switch cable - check the instruction book supplied with your Tape or CD

player.

Before reconnecting power to the circuit, double check all connections are correct and secure. On turning on the CD or

Tape player, the power-on LED next to the power input terminal block of the UCS PRO should light to show the unit is

receiving power.

If the Remote output from the Tape or CD player is already being used to switch on another unit that is

close to the UCS PRO, it is usually possible to 'daisy-chain' a cable from the Remote terminal on that unit

to the REM terminal of the processor. This avoids the need to run a separate cable from the player.

USEFUL USEFUL

TIPTIP

The unit is protected by an internally mounted fuse which only your dealer or an authorized service agent

should replace if it becomes necessary. The replacement fuse must be of the same type and value as

originally fitted.

IMPORTANTIMPORTANT

GROUND

SWITCH

GROUND

SWITCH

UCS PRO is equipped with a Ground Switch. This alters the internal grounding arrangement within the

device. In almost all automotive applications, the switch should be in the LIFT position. In this position, the

power and signal grounds are fully isolated.