User`s manual

LTO

If your UCS PRO has not been set-up yet, or if you want to replace the existing set-up, you can create a new named

profile (NEW UNIT) within the PC Editor. Here's how:

Select NEW from the FILE menu, then UCS PRO and click OK. Select NEW UNIT. In the window that appears, type a

new name for the unit you are creating (this is optional). The Input/Output GANGING (* more information follows) options

should generally be left at their default settings (unchecked).

Press OK and a window corresponding to the unit you have just named will open up with the factory default set-up con-

figuration and the block diagram.

Parameter Menus & System Set-up

USEFUL USEFUL

TIPTIP

*Ganging: The inputs and/or each pair of outputs may be "ganged" (linked together) as stereo pairs, so

that changes are simultaneously applied to both channels. This is achieved via the MODIFY UNIT option

in the ACTIONS menu of the PC Editor. However, if you intend to use the channel delay function for speaker

'time alignment' then you should NOT gang the channels.

IMPORTANTIMPORTANT

Every time a download is made to the UCS PRO, the user presets in the internal memory (and any unsaved

set-up you were working on) are overwritten. Selecting OFFLINE from the ACTIONS menu will cause the

PC to be disconnected from the UCS PRO. Be aware that immediately selecting ONLINE again will prompt

the PC Editor to perform a new scan of the network and automatically download the settings from the PC

to the UCS PRO.

If you do not wish this to happen (i.e. if you do not wish to overwrite the current data in the UCS PRO), then you must

initiate a new session by closing the current window and then selecting NETWORK SCAN (File > New > UCS PRO >

Network Scan) so that the UCS PRO uploads to the PC.

Every time an upload is made, all the USER PRESETS stored in the UCS PRO are transferred to the corresponding

numbered presets within the PC Editor.

Choose ONLINE from the ACTIONS menu and the PC will scan the serial port to verify that the UCS PRO is correctly

connected. The NETWORK SCAN window should show the system status (UNIT CONNECTED or NOT CONNECTED).

Pressing OK will cause all the parameters set in the PC Editor to be downloaded to the UCS PRO. An ONLINE icon will

appear to show that the UCS PRO and PC are now ready to transfer control data in real-time.