User's Manual

5
7.Regulatory Module Integration Instructions
7.1 List of applicable FCC rules
This device complies with part 15.247 of the FCC Rules.
7.2 Summarize the specific operational use conditions
This module can be used in household electrical appliances as well as TV and IP camera. The
input voltage of module should be 3.0~3.6VDC.
7.3 Limited module procedures
Not applicable
7.4 Trace antenna designs
Not applicable
7.5 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body. If the device built into a host as a portable usage, the
additional RF exposure evaluation may be required as specified by §2.1093.
7.6 Antennas
This radio transmitter FCC ID: 2AOXXATBM601X has been approved by Federal Communications
Commission to operate with the antenna types listed below, with the maximum permissible gain
indicated.
Antenna types not included in this list that have a gain greater than the maximum gain indicated
for any type listed are strictly prohibited for use with this device.
Antenna Description Antenna Type Frequency Range Maximum antenna gain
2.4G WiFi Dipole Antenna 2.4GHz-2.5GHz 2.25dBi
7.7 Label and compliance information
The outside of final products that contains this module device must display a label referring to
the enclosed module. This exterior label can use wording such as: “Contains Transmitter Module
FCC ID: 2AOXXATBM601X”, or “Contains FCC ID: 2AOXXATBM601X”, any similar wording that
expresses the same meaning may be used.
7.8 Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module grantee on the required number
of channels, modulation types, and modes, it should not be necessary for the host installer to
retest all the available transmitter modes or settings. It is recommended that the host product
manufacturer, installing the modular transmitter, perform some investigative measurements to
confirm that the resulting composite system does not exceed the spurious emissions limits or
band edge limits (e.g., where a different antenna may be causing additional emissions).