Operating instructions

#825/33/37 INSTALLATION/OPERATION/SERVICE MANUAL PG. 3
SITE INSTALLATION
The Alto-Shaam cook
and hold oven must
be installed in a
location that will
permit the oven to
function for its
intended purpose and
to allow adequate
clearance for
ventilation, proper
cleaning, and
maintenance access.
1. The oven must be installed on a stable and
level surface.
2. DO NOT install this oven in any area where it
may be affected by any adverse conditions such as
steam, grease, dripping water, high temperatures,
etc.
3. DO NOT store or use any flammable liquids or
allow flammable vapors in the vicinity of this
oven or any other appliance.
4. This appliance must be kept free and clear of
any combustible materials.
5. This appliance must be kept free and clear of
any obstructions blocking access for
maintenance or service.
®
TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
DO NOT store or use any flammable
liquids or allow flammable vapors
in the vicinity of any appliance.
IMPROPER INSTALLATION, ALTERATION,
ADJUSTMENT, SERVICE OR MAINTENANCE
COULD RESULT IN SEVERE INJURY, DEATH
OR CAUSE PROPERTY DAMAGE.
INSTALLATION
MINIMUM CLEARANCE REQUIREMENTS
COMBUSTIBLE NON-COMBUSTIBLE
SURFACES SURFACES
BACK 3" (76mm) 3" (76mm)
LEFT SIDE 1" (25mm) 1" (25mm)
RIGHT SIDE 1" (25mm) 1" (25mm)
TOP 2" (51mm) 2" (51mm)
Emissions testing conducted by Underwriters
Laboratories, Inc.® was found to be in
compliance with the applicable requirements of
NFPA96: 2004 Edition, Par. 4.1.1.2. U.L
emissions sampling of grease laden vapor
resulted in a total of 0.55 milligrams per cubic
meter with no visible smoke and is considered
representative of all oven models in the line.
Based on these results, hood installation and/or
outside venting should not be a requirement in
most areas. Verify local codes for locations
where more restrictive codes are applicable.