Operating instructions

PG. 8 #825/33/37 INSTALLATION/OPERATION/SERVICE MANUAL
OPERATING INSTRUCTIONS
USER SAFETY INFORMATION
The Alto-Shaam cook and hold oven is intended
for use in commercial establishments by qualified
operating personnel where all operators are
familiar with the purpose, limitations, and
associated hazards of this appliance. Operating
instructions and warnings must be read and
understood by all operators and users.
START-UP OPERATION
BEFORE INITIAL USE:
Interior oven surfaces must be heated to remove
surface oils and the accompanying odor produced
during the first use of the oven.
1. Wipe all wire shelves, side racks and the full
oven interior with a clean, damp cloth. Install
the oven side racks, oven shelves, and external
drip tray. Shelves are installed with the curved
edge toward the back of the oven. Insert the
drip pan on the interior bottom surface of the
oven.
2. Close the oven doors, press the power switch to
the on position, and set the thermostat to 300°F
(149°C).
3. Allow the oven to cycle for approximately 2
hours or until no odor is detected.
PREHEATING:
Always preheat the oven for a minimum of 20
minutes before cooking product. Follow the
operating instructions indicated on the next page
of this manual.
Metal parts of this equipment become
extremely hot when in operation. To
avoid burns, always use hand protection
when operating this oven.
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND.
DO NOT USE WATER JET TO CLEAN.
SEVERE DAMAGE OR ELECTRICAL
HAZARD COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED.