Installation Guide

- 6 - eBridge4SK
network administrator and repeat the email setup sets.
After all fields have been programed click the button labeled Reboot Server. A dialog box will display “Please allow up to 30 sec. for server to reboot”. Click OK.
All programmed information will be saved after the server has rebooted.
Setup:
Click on the tab labeled Setup. The eBridge4SPT setup page will open. In this screen the Site ID, Date/Time and Port identification are setup, along with the
ability to enable and disable individual ports.
Site ID (Fig. 3a, pg. 6): Enter a descriptive name that will identify the location of the eBridge4SPT. The Site ID will appear in both the trap message and email
notifications.
Date/Time (Fig. 3b, pg. 6): Time and Date can be entered two different ways manually or by syncing the date and time with the host computer.
Manual setup (Fig. 3b, pg. 6): Individually select the appropriate information for each of the required field then click Update. This will update time of the
eBridge4SPT to the programmed information. The manual setup can be used when programming devices installed in one time zone and monitored in another.
Sync Setup (Fig. 3b, pg. 6): Clicking the button labeled Sync Date/Time with computer will set the eBridge4SPT to the time of the host computer.
Port ID (Fig. 3c, pg. 6): Enter a descriptive name and/or location of the device connected to the port.
Port Status (Fig. 3d, pg. 6): Individual ports can be enabled or disabled by clicking the button labeled Enable Port/Disable Port. This feature allows unused
ports to be disabled and also can be used to reboot a connected device by cycling power OFF and ON.
After all fields have been programmed click on the button labeled Save Settings.
Fig. 3
Setup
eBridge4SPT
Jul
Site ID:
Save Settings
Trap Receiver Settings:
Port
1
Port ID Port Status
Update Site IDRJ Sports Wear
Update
Disable Port
Sync Date/Time with computer
EnabledMain Entrance
201515 32 53 am9[ : : ]
Management Interface
Events Log
v1.99.22
Security SettingsNetwork SettingsSetupStatus
2
Disable Port
EnabledProduction
3
Disable Port
EnabledReceiving
4
Disable Port
EnabledShipping
b.
a.
c. d.