Installation Guide

eBridge8PCRM/16PCRM - 3 -
Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due
to uneven mechanical loading.
Circuit Overloading - Consideration should be given to the connection of the equipment to supply circuit and the effect that
overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment
nameplate rating should be used when addressing this concern.
Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given
to supply connections other than direct connections to the branch circuit (e.g. use of power strips).
1. eBridge8PCRM/16PCRMinstallation:
a. Attach mounting brackets to eBridge8PCRM/16PCRM unit for rack installation (Fig. 4, pg. 6).
Affix rubber pads to eBridge8PCRM/16PCRM for shelf installation (Fig. 5, pg. 6).
  Unitshouldbelocatedinproximitytoethernetswitch/network,NVRorvideoserver.
 b.ConnectstructuredcablefromethernetmidspanorendspandevicetoRJ45jackmarked[10/100BaseT]
(Fig. 2, pg. 3).
 c. ConnectCoaxcabletoBNCconnectormarked[Coax](Fig. 1, pg. 3).
2. eBridge1PCTXinstallation:
a. Secure unit to desired mounting surface with a proper fastening device utilizing the case’s mounting hole.
Unit should be mounted in proximity of camera/device.
 b.ConnectstructuredcablefromIPcamera/devicetoRJ45jackmarked[10/100BaseT](Fig. 2, pg. 3).
 c. ConnectCoaxcabletoBNCconnectormarked[Coax](Fig. 2, pg. 3).
Note:TheeBridge8PCRM/16PCRMisdesignedtoaccommodateMegapixel,HD720,HD1080andVGA(SD)cameras.
It is important to note that some high resolution and high frame rate cameras may demand faster headend processing abil-
ity, such as a PC graphics card to present a quality image. If the headend processing equipment is insufficient in speed, the
image may show pixelation and latency. It is advisable to pretest system if unsure. Alternatively, frame rate and resolution
may be reduced to accommodate system equipment.
Fig. 1
eBridge8PCRM
Data In Data In
12345678
10/100
Base-T
1234
10/100
Base-T
5678
eBridge8PCRM (rear)
eBridge8PCRM (front)
Structured
Cable from
midspan/endspan
Coax
Cable from
eBridge1PCT or
eBridge1PCTX
Data In Data In Data In Data In
12345678910111213141516
10/100
Base-T
1234
10/100
Base-T
5678
10/100
Base-T
910111213141516
eBridge16PCRM
(rear)
eBridge16PCRM (front)
Structured
Cable from
midspan/endspan
Coax
Cable from
eBridge1PCT or
eBridge1PCTX
Fig. 1a
eBridge16PCRM