Power over the Ethernet PoE Solution for Standard Network Infrastructure Installation Guide Models Include: NetWay8 - Eight (8) Port PoE Midspan Injector NetWay16 - Sixteen (16) Port PoE Midspan Injector DOC#: NET Rev. 052110 More than just power.
Table of Contents: Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . pg. 3 NetWay Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview: Altronix NetWay8 and NetWay16 Midspans provide power and pass data for PoE and PoE+ compliant cameras/ edge devices. Cameras/edge devices may be located up to 100m from the NetWay unit. A NetWayXT (PoE) or NetWayXTX (PoE+) repeater module can be utilized to extend the distance an additional 100m for a total range of up to 200m. A maximum range of 600m is possible using multiple repeaters, based on camera/device port requirement.
3. Set illuminated master power disconnect circuit breaker to the (OFF) position (Fig. 1d, pg. 4). 4. Plug the grounded AC line cord (included) into the IEC 320 connector of the NetWay unit (Fig. 1e, pg. 4). Plug unit into a reliable earth grounded socket. When using multiple units the sum of the individual name plate ratings should not exceed the supply circuit rating. Do not connect to a receptacle controlled by a switch. 5.
Installing a NetWay1512 Adapter for 12VDC IP Cameras up to 13W: 1. Mount NetWay1512 in proximity to IP camera Fig. 2 - NetWay1512 (Fig. 2, pg. 5). Affix one side of velcro (supplied) to NetWay1512 and the place the second side of the velcro in the desired location. 2. Connect structured cable from port marked [IN] on Netway1512 NetWay1512 to any ports marked [OUT] of Adapter www.altronix.com NetWay8/NetWay16 (Fig. 2, pg. 5, Fig. 1a, pg. 4). Structured 12VDC 3.
NetWay8/NetWay16 Typical Application: Fig. 5 NetWayXT/NetWayXTX Extends Ethernet 100m (328 ft.) I.T.E. 43KC NetwayXT Repeater PoE Camera Card Reader www.altronix.com Power OUT IN PoE Camera Strike HID Solo PoE + Camera NetWay1512 Netway1512 12VDC IP camera I.T.E. 43KC Adapter www.altronix.com IN OUT 12VDC + Output --- NetWay8 Ethernet Switch NVR/Network Server Technical Specifications: Parameter Description No. of Ports NetWay8 - Eight (8) Ports. NetWay16 - Sixteen (16) Ports.
NetWay8/NetWay16 Rack Mount Chassis Mechanical Drawing and Dimensions: Fig. 6 0.75" (19.1mm) 19.125" (485.8mm) 17.625" (447.7mm) 8.5" (215.9mm) 1.625" (41.3mm) AC POWER (ON) The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of an insulated DANGEROUS VOLTAGE within the product’s enclosure that may be of sufficient magnitude to constitute an electric shock.
Rack Mount Installation Mounting Options: 1. Remove and discard factory installed screws from both sides of rack chassis (Fig. 6a). 2. Install mounting brackets (A) on the left and right side of rack chassis using the four (4) flat head screws (B) (included) (Fig. 6b). 3. Place unit into desired EIA 19” rack position and secure with mounting screws (not included) (Fig. 6c). Fig. 6 Fig. 6a Fig. 6b Top Fig. 6c Top Top Front Left Front Left Front Left B Remove A Wall Mount Installation 1.
