Installation Guide

Trove / CDVI - 3 -

Standoff

CDVI - A22NB

Access Controller

Backplane

Fig. 2b

TC1: Configuration of Altronix Power Supply

and/or Sub-Assembly Boards and CDVI Modules

1. Fasten standoffs (provided) to pems that match the hole pattern for Altronix Power Supply/Chargers or Altronix Sub-Assembly boards

(Fig. 2, pg. 3). Fasten metal standoffs in the correct locations to provide proper grounding, see below (Fig. 2, pg. 3).

2. Mount boards to standoffs utilizing 5/16” pan head screws (provided) (Fig. 2a, pg. 3).

3. Mount appropriate CDVI A22NB modules into the correct positions (Fig. 2, pg. 3) by postioning standoffs over appropriate holes on

the backplane and depress down on board to secure standoff to the backplane (Fig. 2, 2b, 2c, pg. 3).

Note: CDVI A22NB modules have one (1) RJ45 jack each. Please make sure that they are mounted correctly, as shown in Fig. 2 below.

4. Fasten TC1 backplane to Trove1 enclosure utilizing pan head screws (provided).

Fig. 2 - Trove1C1/TC1 Conﬁgurations

Plastic Standoff

pre-mounted into

CDVI Atrium modules

Insert into

TC1/TCV2/TCV3 backplane

Fig. 2c

CDVI - A22NB CDVI - A22NBCDVI - A22NB

Altronix

Power

Supply

Altronix

Sub-

Assembly

Metal

Standoff

Placement

RJ45 Jack RJ45 Jack RJ45 Jack

RJ45 JackRJ45 JackRJ45 Jack

Pem

Standoff

Altronix

Power Supply or

Sub-Assembly

Backplane

Pan Head

Screw

Fig. 2a