Installation Guide

- 4 - Trove / CDVI

Altronix

Power Supply

Altronix

Power Supply or

Sub-Assembly

CDVI - A22NB

CDVI - A22NBCDVI - A22NB

Altronix

Sub-Assembly

Metal Standoff Placement

RJ45 Jack RJ45 Jack

RJ45 Jack

TCV2: Configuration of Altronix Power Supply

and/or Sub-Assembly Boards and CDVI Modules

1. Fasten standoffs (provided) to pems that match the hole pattern for Altronix Power Supply/Chargers or Altronix Sub-Assembly boards

(Fig. 3, pg. 4). Fasten metal standoffs in the correct locations to provide proper grounding, see below (Fig. 3, pg. 4).

Note: Altronix sub-assembly position can accommodate either one (1) ACM8/ACM8CB or two (2) PD4UL/PD4ULCB,

PD8UL/PD8ULCB or MOM5.

2. Mount boards to standoffs utilizing 5/16” pan head screws (provided) (Fig. 3a, pg. 4).

3. Mount appropriate CDVI A22NB modules into the correct positions (Fig. 3, pg. 4). by positioning standoffs over appropriate holes on

the backplane and depress down on board to secure standoff to the backplane (Fig. 3, 3b, 3c, pg. 4).

Note: CDVI A22NB modules have one (1) RJ45 jack each. Please make sure that they are mounted correctly, as shown in Fig. 3 below.

4. Fasten TCV2 backplane to Trove2 enclosure utilizing pan head screws (provided).

Fig. 3 - Trove2CV2/TCV2 Conﬁgurations

Standoff

CDVI - A22NB

Access Controller

Backplane

Fig. 3b

Plastic Standoff

pre-mounted into

CDVI Atrium modules

Insert into

TC1/TCV2/TCV3 backplane

Fig. 3c

Pem

Standoff

Altronix

Power Supply or

Sub-Assembly

Backplane

Pan Head

Screw

Fig. 3a