Installation Guide

Trove / CDVI - 5 -
Altronix
Power Supply
Metal
Standoff
Placement
Altronix
Power Supply
Metal
Standoff
Placement
Altronix
Sub-Assembly
Altronix
Sub-Assembly
Altronix
Sub-Assembly
Altronix
Sub-Assembly
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
CDVI - A22NB
RJ45 Jack
TCV3: Configuration of Altronix Power Supply
and/or Sub-Assembly Boards and CDVI Modules
1. Fasten standoffs (provided) to pems that match the hole pattern for Altronix Power Supply/Chargers or Altronix Sub-Assembly boards
(Fig. 4, pg. 5). Fasten metal standoffs in the correct locations to provide proper grounding, see below (Fig. 4, pg. 5).
Note: Altronix sub-assembly positions can accommodate two (2) PD4UL/PD4ULCB, PD8UL/PD8ULCB or MOM5.
2. Mount boards to standoffs utilizing 5/16” pan head screws (provided) (Fig. 4a, pg. 5).
3. Mount appropriate CDVI A22NB modules into the correct positions (Fig. 4, pg. 5). by positioning standoffs over appropriate holes on
the backplane and depress down on board to secure standoff to the backplane (Fig. 4, 4b, 4c, pg. 5).
Note: CDVI A22NB modules have one (1) RJ45 jack each. Please make sure that they are mounted correctly, as shown in Fig. 4 below.
4. TCV3 backplane installation: refer to note below drawing and Fig. 4d, pg. 5.
5. Fasten TCV3 backplane to Trove3 enclosure utilizing pan head screws (provided).
Fig. 4 - Trove3CV3/TCV3 Configurations
Standoff
CDVI - A22NB
Access Controller
Backplane
Fig. 4b
Plastic Standoff
pre-mounted into
CDVI Atrium modules
Insert into
TC1/TCV2/TCV3 backplane
Back of
Backplane
Rubber
Bumper
Cutout
Fig. 4c
Fig. 4d
Pem
Standoff
Altronix
Power Supply or
Sub-Assembly
Backplane
Pan Head
Screw
Fig. 4a
Note: TCV3 bumper installation.
Prior to mounting TCV3 install rubber bumpers
(included) to the back of backplane, one (1) on
top and one (1) on bottom, approximately 1”
from the cutouts (Fig. 4d, pg. 5).
Bumpers are pre-installed in Trove3CV3