Installation Guide

Trove2BH2 - 3 -

C C C

Installation Instructions for Bosch Boards to TBH2:

Mounting Bosch B520 Power Supply:

1. Fasten standoffs (provided) into hole configuration (A) of backplane (Fig. 3, pg. 3).

2. Mount boards to standoffs utilizing 5/16” pan head screws (provided) (Fig. 3a, pg. 3).

Mounting Bosch B8512G/B9512G IP Control Panels:

1. Fasten lock nuts onto top two (2) pems, leaving enough space to accommodate B8512G/B9512G.

2. Slide top mounting holes of B8512G/B9512G over pems of backplane configuration (B) (Fig. 3, pg. 3).

3. Fasten 5/16” pan head screw (provided) through mounting hole of B8512G/B9512G (Fig. 3a, pg. 3).

Mounting Bosch Modules:

1. Utilize mounting bracket to mount Bosch modules to the backplane configurations (C)

(Fig. 3, pg. 3).

Bosch Board Position Chart:

Bosch Board(s) Mounting

Power Supply

B520 A

Controllers

D7412GV4, D9412GV4, B8512G, B9512G B

Access Control*

B901

Expansion Modules*

B299, B600, D8128D, D8125/MUX, D8129

Interface Cards*

D125B, D129, D132A, D185, D192G, D8130

SDI/2 Devices*

B208, B308, B426, B450, ICP-SDI-9114

Fig. 3

Standoff

Bosch

Sub-Assembly

Backplane

Pan Head

Screw

Pem

Fig. 3a

* These boards have the same keyhole

mounting bracket (Fig. 3, pg. 3). Position

them according to your specific design.