User's Manual
Table Of Contents
- Revision History
- 1. Installation and General Information
- 1.1 Introduction
- 1.2 Installing iOS App from Apple App Store
- 1.3 Installing Android App
- 1.4 Installing the Sentinare Sensor
- 1.5 Disclaimers, Limitations and Known Issues
- 1.6 Troubleshooting
- 1.7 Technical Support
- 1.8 Certificates
- 1.9. Federal Communications Commission (FCC) Interference Statement
- 1.10 Innovation, Science and Economic Development Canada (ISED) Interference Statement
- 2. User Account Management
- 3．Room Management
- 4．Device Management
- 4.1 Add a Device
- 4.2 Device Streaming and Setting
- 4.2.1 Rename Device
- 4.2.2 Refresh Display
- 4.2.3 Voice Call
- 4.2.4 Setup WiFi
- 4.2.5 Calibration
- 4.2.6 Region of Interest (ROI)
- 4.2.7 View Recordings
- 4.2.8 Updating Firmware
- 4.2.9 Restart
- 4.2.10 Change Room
- 4.2.11 Remove Device
- 4.2.12 Privacy Mode
- 4.2.13 Upside-Down Installation
- 4.2.14 Delay Fall Alert
- 4.2.15 Hand Waving Detection and Sensitivity
- 4.2.16 Advanced Settings
- 4.2.17 Factory Reset
- 4.2.18 Configuring Night Vision
- 4.2.19 LED Green Light
- 4.2.20 Alert Sound
- 4.2.21 Stick Figure Recording
- 4.2.22 HDMI Output (Cypress Only)
- 4.2.23 Local Video Recording (Cypress Only)
- 4.2.24 Meanings of LED Colors
- 5．People Management
- 6．Alerts
- 7．Fall Risk Assessment
- 7.1 Introduction
- 8．Dashboard
- 9. Account Settings
- 10. Sentinare Web Hub
- 11. API for Third-Party Integration
28
In the WiFi networks listed by the Sentinare App, select the desired WiFi network and enter its
password, the LED on the sensor will first turn to red, then change to yellow and blue, and eventually
shows a steady green light. After that, this sensor will be successfully added to the account, and will
appear in the list of sensors in the selected room.
If your desired WiFi network is not shown in the list, you can rescan the networks for a few times,
especially when the WiFi signal is not strong. Please also make sure your WiFi network meets the
requirements above.
After a sensor is added into an account, the WiFi can be re-configured, as shown in Section 4.2.3.