User's Manual
Table Of Contents
- Revision History
- 1. Installation and General Information
- 1.1 Introduction
- 1.2 Installing iOS App from Apple App Store
- 1.3 Installing Android App
- 1.4 Installing the Sentinare Sensor
- 1.5 Disclaimers, Limitations and Known Issues
- 1.6 Troubleshooting
- 1.7 Technical Support
- 1.8 Certificates
- 1.9. Federal Communications Commission (FCC) Interference Statement
- 1.10 Innovation, Science and Economic Development Canada (ISED) Interference Statement
- 2. User Account Management
- 3．Room Management
- 4．Device Management
- 4.1 Add a Device
- 4.2 Device Streaming and Setting
- 4.2.1 Rename Device
- 4.2.2 Refresh Display
- 4.2.3 Voice Call
- 4.2.4 Setup WiFi
- 4.2.5 Calibration
- 4.2.6 Region of Interest (ROI)
- 4.2.7 View Recordings
- 4.2.8 Updating Firmware
- 4.2.9 Restart
- 4.2.10 Change Room
- 4.2.11 Remove Device
- 4.2.12 Privacy Mode
- 4.2.13 Upside-Down Installation
- 4.2.14 Delay Fall Alert
- 4.2.15 Hand Waving Detection and Sensitivity
- 4.2.16 Advanced Settings
- 4.2.17 Factory Reset
- 4.2.18 Configuring Night Vision
- 4.2.19 LED Green Light
- 4.2.20 Alert Sound
- 4.2.21 Stick Figure Recording
- 4.2.22 HDMI Output (Cypress Only)
- 4.2.23 Local Video Recording (Cypress Only)
- 4.2.24 Meanings of LED Colors
- 5．People Management
- 6．Alerts
- 7．Fall Risk Assessment
- 7.1 Introduction
- 8．Dashboard
- 9. Account Settings
- 10. Sentinare Web Hub
- 11. API for Third-Party Integration
34
Note that if the account already has some people’s information (including their faces), the face features
will be downloaded to a newly added sensor after the calibration, during which the sensor will display
blue light. Once the download finishes and the light becomes green, the sensor will be able to recognize
these people and the App will display their names in the steaming page.
There are some important settings that affect the behaviors of the sensor, such as the following. Please
refer to the corresponding sections for details.
• Upside-Down Installation (Sec. 4)
• Delay Fall Alert (Sec. 4)
• Push Notification Status (Sec. 8)
• Duplicate Alert Prevention (Sec. 8)
4.2 Device Streaming and Setting
In the individual room page, tap on a sensor in the sensor list will enter the sensor's streaming and
setting page, as shown below. This page allows users to view the video stream from the sensor in real
time (people are rendered by stick-figure animation to protect privacy) and configure the device, such as
renaming device, refresh the display, start voice call, setting up WiFi, calibrating device, defining Region
of Interest, checking recorded stick figures, updating device firmware, restarting device, moving device
to another room, and removing device from system.
Users can also turn on or turn off some features, such as Delay Fall Alert, LED Green Light, Alert Sound,
Hand-Waving Detection, and Hand-Waving Sensitivity.
Users can also access some advanced settings by tapping the Show Advanced Settings command, such
as serial number of the device, flipping device view, turning on/off some other features. The details are
explained below.