User's Manual
Table Of Contents
- Revision History
- 1. Installation and General Information
- 1.1 Introduction
- 1.2 Installing iOS App from Apple App Store
- 1.3 Installing Android App
- 1.4 Installing the Sentinare Sensor
- 1.5 Disclaimers, Limitations and Known Issues
- 1.6 Troubleshooting
- 1.7 Technical Support
- 1.8 Certificates
- 1.9. Federal Communications Commission (FCC) Interference Statement
- 1.10 Innovation, Science and Economic Development Canada (ISED) Interference Statement
- 2. User Account Management
- 3.Room Management
- 4.Device Management
- 4.1 Add a Device
- 4.2 Device Streaming and Setting
- 4.2.1 Rename Device
- 4.2.2 Refresh Display
- 4.2.3 Voice Call
- 4.2.4 Setup WiFi
- 4.2.5 Calibration
- 4.2.6 Region of Interest (ROI)
- 4.2.7 View Recordings
- 4.2.8 Updating Firmware
- 4.2.9 Restart
- 4.2.10 Change Room
- 4.2.11 Remove Device
- 4.2.12 Privacy Mode
- 4.2.13 Upside-Down Installation
- 4.2.14 Delay Fall Alert
- 4.2.15 Hand Waving Detection and Sensitivity
- 4.2.16 Advanced Settings
- 4.2.17 Factory Reset
- 4.2.18 Configuring Night Vision
- 4.2.19 LED Green Light
- 4.2.20 Alert Sound
- 4.2.21 Stick Figure Recording
- 4.2.22 HDMI Output (Cypress Only)
- 4.2.23 Local Video Recording (Cypress Only)
- 4.2.24 Meanings of LED Colors
- 5.People Management
- 6.Alerts
- 7.Fall Risk Assessment
- 7.1 Introduction
- 8.Dashboard
- 9. Account Settings
- 10. Sentinare Web Hub
- 11. API for Third-Party Integration
46
When the Alert Sound flag is On, the sensor will play a sound when sending an alert, otherwise it will not
play a sound when sending an alert.
4.2.21 Stick Figure Recording
This toggle is used to turn on (default) or turn off the stick figure recording in the server. When the
toggle is on, whenever a person is detected by a sensor, the stick figure activities will be recorded in the
server. The recording can be accessed from the View Recordings page, as described in Sec. 4.2.7.
4.2.22 HDMI Output (Cypress Only)
Some Cypress sensors have HDMI output, which can be used to display the background image and stick
figures on big screen TV. This is very useful for demo purpose.
For these sensors with HDMI output, the Advanced Setting includes a “HDMI Output” toggle switch,
which can be used to turn on or off the HDMI output port of the activity sensor. The default value is Off.
The change of “HDMI output” will restart the device to make the change effective.
The display device required by HDMI output is 1080P resolution and 60 frame/sec.