User's Manual
Table Of Contents
- Revision History
- 1. Installation and General Information
- 1.1 Introduction
- 1.2 Installing iOS App from Apple App Store
- 1.3 Installing Android App
- 1.4 Installing the Sentinare Sensor
- 1.5 Disclaimers, Limitations and Known Issues
- 1.6 Troubleshooting
- 1.7 Technical Support
- 1.8 Certificates
- 1.9. Federal Communications Commission (FCC) Interference Statement
- 1.10 Innovation, Science and Economic Development Canada (ISED) Interference Statement
- 2. User Account Management
- 3.Room Management
- 4.Device Management
- 4.1 Add a Device
- 4.2 Device Streaming and Setting
- 4.2.1 Rename Device
- 4.2.2 Refresh Display
- 4.2.3 Voice Call
- 4.2.4 Setup WiFi
- 4.2.5 Calibration
- 4.2.6 Region of Interest (ROI)
- 4.2.7 View Recordings
- 4.2.8 Updating Firmware
- 4.2.9 Restart
- 4.2.10 Change Room
- 4.2.11 Remove Device
- 4.2.12 Privacy Mode
- 4.2.13 Upside-Down Installation
- 4.2.14 Delay Fall Alert
- 4.2.15 Hand Waving Detection and Sensitivity
- 4.2.16 Advanced Settings
- 4.2.17 Factory Reset
- 4.2.18 Configuring Night Vision
- 4.2.19 LED Green Light
- 4.2.20 Alert Sound
- 4.2.21 Stick Figure Recording
- 4.2.22 HDMI Output (Cypress Only)
- 4.2.23 Local Video Recording (Cypress Only)
- 4.2.24 Meanings of LED Colors
- 5.People Management
- 6.Alerts
- 7.Fall Risk Assessment
- 7.1 Introduction
- 8.Dashboard
- 9. Account Settings
- 10. Sentinare Web Hub
- 11. API for Third-Party Integration
49
In the Manager Person Groups page, user can add a new person group by tapping the “+ Add Person
Group” command. In the New Person Group page, user can specify the name of the new person group
and the type of the person group. Currently, only three types are supported, namely Senior, Staff, and
Visitors. Each of the three pre-defined person groups belong to one of the three person group types.
Only the administrator can manage Person Group.
5.2. Add Person
Only administrators can add new person. To add a person, tap on "+Add Person" at the top of the
“People” page. The App first needs to get a front image of the person from the camera or from the
image library, as shown by the figure below. Please make sure the entire head of the person is in the
circle.
After getting a face image, the “Add Person” page will appear, where the user can input the name of the
person and assign this person to a person group, as shown below.