User's Manual
Table Of Contents
- Revision History
- 1. Installation and General Information
- 1.1 Introduction
- 1.2 Installing iOS App from Apple App Store
- 1.3 Installing Android App
- 1.4 Installing the Sentinare Sensor
- 1.5 Disclaimers, Limitations and Known Issues
- 1.6 Troubleshooting
- 1.7 Technical Support
- 1.8 Certificates
- 1.9. Federal Communications Commission (FCC) Interference Statement
- 1.10 Innovation, Science and Economic Development Canada (ISED) Interference Statement
- 2. User Account Management
- 3.Room Management
- 4.Device Management
- 4.1 Add a Device
- 4.2 Device Streaming and Setting
- 4.2.1 Rename Device
- 4.2.2 Refresh Display
- 4.2.3 Voice Call
- 4.2.4 Setup WiFi
- 4.2.5 Calibration
- 4.2.6 Region of Interest (ROI)
- 4.2.7 View Recordings
- 4.2.8 Updating Firmware
- 4.2.9 Restart
- 4.2.10 Change Room
- 4.2.11 Remove Device
- 4.2.12 Privacy Mode
- 4.2.13 Upside-Down Installation
- 4.2.14 Delay Fall Alert
- 4.2.15 Hand Waving Detection and Sensitivity
- 4.2.16 Advanced Settings
- 4.2.17 Factory Reset
- 4.2.18 Configuring Night Vision
- 4.2.19 LED Green Light
- 4.2.20 Alert Sound
- 4.2.21 Stick Figure Recording
- 4.2.22 HDMI Output (Cypress Only)
- 4.2.23 Local Video Recording (Cypress Only)
- 4.2.24 Meanings of LED Colors
- 5.People Management
- 6.Alerts
- 7.Fall Risk Assessment
- 7.1 Introduction
- 8.Dashboard
- 9. Account Settings
- 10. Sentinare Web Hub
- 11. API for Third-Party Integration
77
10.3 Alerts
In the menu, click on the “Alert” option, or the bell icon on the top right corner of the web page, all the
alerts in the account will be listed. The alert list is the same as that shown in the Sentinare mobile App.
Users can use the “filter” button on the top of the page to filter the alerts, or play the alert clip by
clicking the icon under the Actions, as shown below.
10.4 Select Streams
In the menu, click Select Streams, users can select up to 12 sensors from different Rooms, then click the
Start Streams command in the upper right corner. This will display the real-time views from the selected
sensors in the same page.