Specifications

• If you enabled Check Firmware Version, the Utility compares the

KVM device’s firmware version with that of the upgrade files. If the

device firmware version is higher, an alert message appears. Click Yes

to continue or No to cancel the upgrade.

• If you didn’t enable Check Firmware Version, the Utility installs the

upgrade files without comparing the device version with that of the

upgrade files.

7.To abort the upgrade procedure before completion, click Cancel. An alert

message appears warning you that quitting at this point may cause the

device’s firmware to be lost. You have the option to proceed with the

cancel operation or abort the cancel operation.

NOTE: To recover from a “lost firmware” situation, see the Firmware Upgrade Reset

Switch information on page 18.

Upgrade Succeeded

After the upgrade has completed, a screen appears to inform you that the

procedure was successful: