Manual
EPH-N00-06007
10-21-04
Page 7 of 8
Adjust the drip vinyl [X] by sliding it left or right
until it just touches the curb. Trim the vinyl (flush with
the pivot end and notch 1/2" longer than the drip rail as
shown on the strike end). Secure it with one #6 x 3/8"
truss head screw [F] in the pivot end of the drip rail.
The drip plug [Y] is supplied with a left and right hand
plug together. Break the right and left drip plug apart and
insert the appropriate plug into the high (strike) side of
the drip rail. Discard the unused drip plug. Peel off the
tape backing and carefully press the drip rail to the door in the
marked position.
12
Cut the drip rail [W] to the length of the complete
bottom rail minus 11/16". Clean the inside edge of the
bottom door rail and the flat side of the drip rail thoroughly
to ensure proper adhesion of the double stick tape [B].
Unroll the tape and carefully attach it to the back of the drip
rail (do not peel the tape backing yet).
Insert the tapered drip vinyl [X] into the drip rail. Position
the drip rail flush with the bottom and pivot side of the door
panel [L], then raise the strike side until the bottom edge of
the drip vinyl is parallel to the curb [A]. Mark the location
of each end of the drip rail with a pencil.
NOTE: Cleaners with alcohol content can dissolve the
adhesive that attaches the drip rail. To prevent this possi-
bility, place a small bead of clear sealant at the top of the drip
rail where it is attached to the bottom rail.
11
GLASS
HANDLE
VINYL
MAGNETIC
LATCH
STRIKE
JAMB
PULL
HANDLE
1/8"
Slide the door handle [U] with magnet onto the strike
edge of the door panel [L]. Close the door and slide the
handle up or down until the two magnetic strips are aligned.
Use a pencil or masking tape to mark the location of the
handle on the door.
Slip the door handle vinyl [V] onto the door between the
marks and carefully drive the door handle on the door panel.
Spraying glass cleaner or water onto the vinyl and handle will
make assembly easier.
Close the door and check the clearance with the strike jamb.
If necessary, loosen the set screws [N] on the top & bottom
pivot blocks [P] and adjust the door to align the strike
magnets. When the door is properly aligned, tighten the set
screws securely.
10