User Manual

Page 7 of 8

G03711066

6-9-2014

Lift the interior glass panel into position with the

rollers engaging the groove in the header [F]. Repeat

for the exterior panel. If panels are not parallel to their

respective wall jambs, remove and adjust the rollers up

or down in their slots to compensate.

Slide the stainless steel bumper inserts [U] into the

two soft vinyl jamb bumpers [V]. Align the slots in the

bumpers with the glass panels and snap the bumpers

downward over the center wall jamb screws [D] with the

spacers [E].

Locate the nylon bottom guide [S] in the middle

of the tub track [A] with the glass panels in the position

shown. With a 7/64" bit, drill two holes into the V-groove

through the mounting holes in the guide. Install the bot-

tom guide with two #6 x 3/8" pan head screws [T] thru

the drilled holes as shown.

INSERT

SCREW &

SPACER

WALL

JAMB

MOLDED

BUMPER