User guide

Page 1 of 4

9-11-03

STIKSTALL

INSTRUCTION SUPPLEMENT

390cv CONTINUOUS HINGE

FRAMELESS DOOR KIT

This Alumax 390cv Continuous Hinge door panel kit is designed to be

installed in our StikStall framework with an in-line panel (391), a return panel

(392), an in-line and a return panel (393), a neo-angle unit (394), or between two

in-line panels (395).

To ensure correct installation, this instruction supplement (packed with a

glazed or KD door panel kit) is de

signed to be used with a StikStall Installation

Instruction sheet (391, 392, 393, 394, 395) that will be packaged with the

corresponding StikStall frame kit. Each step in the primary instruction sheet will

indicate whether it applies to all door types or if this supplement should be used.

Tel: 80

G03711141

0-643-1514

www.alumaxshowerdoor.com

PAGE 1
Tel: 800-643-1514 www.alumaxshowerdoor.com 390cv CONTINUOUS HINGE FRAMELESS DOOR KIT STIKSTALL INSTRUCTION SUPPLEMENT This Alumax 390cv Continuous Hinge door panel kit is designed to be installed in our StikStall framework with an in-line panel (391), a return panel (392), an in-line and a return panel (393), a neo-angle unit (394), or between two in-line panels (395).
PAGE 2
390cv PARTS LIST *A. *B. *C. *D. *E. *F. *G. *H. *J. *K. *L. *M.
PAGE 3
1 Press the hinge jamb/door panel assembly [*A] and strike jamb [*B] (with magnetic strip) over the wall jamb and/or framing posts. Refer to Step #1 of the STIKSTALL instruction sheet for the proper handing of the door. Adjust the door panel assembly so there is 1/4" clearance between the strike jamb and the strike edge of the glass door panel in the closed position. Mark the location of the hinge jamb on the wall jamb (or post).
PAGE 4
Slide the latch [*F] with magnet onto the strike edge of the door panel. Close the door and slide the latch up or down until the two magnetic strips are aligned. Use a pencil or masking tape to mark the location of the latch on the door. Wrap the latch vinyl [*E] over the edge of the door glass between the marks and carefully drive the door latch onto the door panel. Spraying glass cleaner or water onto the vinyl will make assembly easier.