User guide

Page 3 of 4 EPH-N00-06096

9-11-03

Press the hinge jamb/door panel assembly [*A] and

strike jamb [*B ] (with magnetic strip) over the wall jamb

and/or framing posts. Refer to Step #1 of the STIKSTALL

instruction sheet for the proper handing of the door.

Adjust the door panel assembly so there is 1/4" clearance

between the strike jamb and the strike edge of the glass

door panel in the closed position. Mark the location of the

hinge jamb on the wall jamb (or post).

NOTE: The magnetic strip on the strike jamb must face

the exterior and the door panel must open outward.

Snap both fillers [*C] into the curb and header between

the hinge and strike jambs with the raised lips to the exterior.

Center the curb filler between the hinge and strike jamb (use

masking tape to hold in position).

NOTE: The snap-in fillers should be exactly 7/16" longer

than the door panel width.

Pull the bottom end of the hinge jamb tight to the

curb filler [*C ] and plumb the jamb. Drill two 1/8" holes

thru the hinge jamb and into the wall jamb (or post) 3/8" to

3/4" from the wall and approximately 1/4" vertically from

the ends of the jamb. Drill a third hole centered between

the first two and enlarge the outer holes with a 3/16" drill

for clearance on the self-tapping screws. Attach the

hinge jamb/door panel permanently with three #8 x 1/4"

truss head screws [*D].

Slide the header filler [*C] tight against the hinge jamb.

Push the strike jamb [*B] tight against the fillers top and

bottom. With the hinge jamb plumb and both fillers tight

between the two door jambs, the strike jamb also will be

plumb and parallel to the hinge jamb. Attach the strike

jamb in the same manner as the hinge jamb.