Manual

EPH-N00-06009
5-20-97
Page 10 of 11
19
20
Inspect the pieces of black glazing vinyl,
and note the two different profiles. The smaller
shape [HH] is installed vertically and the larger
shape [JJ] is installed horizontally. For structural
strength and maximum water resistance, these
vinyls are designed to fit tightly between the glass
and framing. To speed installation, use glass
cleaner for lubrication and a small block of wood to
press the vinyl into place.
NOTE: These glazing vinyls have been pre-
lubricated with a water-based silicone compound.
Wash hands thoroughly after glazing and avoid
contact with eyes or mouth.
Cut four pieces of the smaller vinyl [HH] 1"
longer than the vertical opening (to prevent
gapping from shrinkage) and trim the ends on a
45° angle. Using the masking tape guides, center
the glass panel [F] in the frame. Cut four short (1"
- 2") pieces of the small vinyl and press into the
jamb and post on each side to hold the glass
temporarily.
Take one of the long pieces of vinyl, and starting
on the outside exterior jamb, press each end into
the frame and work toward the middle. Be careful
not to stretch the vinyl. Install the other three
pieces in a similar fashion.
21
Cut four pieces of the larger vinyl [JJ] 1/2"
longer than the horizontal opening and trim the
ends on a 45° angle. Install the top exterior vinyl
starting at both ends and working toward the
middle. Be careful not to stretch the vinyl.
Install the top interior vinyl and the two bottom
vinyls in the same way.
1/4" GLASS
REQUIRES:
FIXED GLASS PANEL
VERTICAL
HORIZONTAL
V-219
V-220
3/16" GLASS
REQUIRES:
V-226 V-225
NOTCH
NOTCH
STANDARD SIZES
SHIPPED WITH
4 PIECE VINYLS
(TEAR APART)