Manual

EPH-N00-06009
5-20-97
Page 4 of 11
1
The ALUMAX 391 STIKSTALL Shower Enclosure
is completely reversible and may be installed
pivot-left or pivot-right. The door may pivot from
the wall or from the center post. For maximum
waterproofing, the pivot jamb should always be
opposite the shower head. Using the illustration,
determine the correct position for the door in your
particular STIKSTALL installation. This instruction
sheet depicts a pivot-right installation.
NOTE: Fixed glass panel size should be determined
by formulas shown on A
LUMAX detail sheets.
CAUTION: For safety reasons, the door panel
must always open outward.
2
Measure the wall-to-wall opening at the
shower sill and cut the curb [A] (with weep slots)
to fit the full width of the opening. If necessary,
use a file to round the lower corners of the curb to
fit the shower sill properly.
Using a 3/16" drill bit, drill the interior face of the
curb on both ends as shown.
Position the curb in the middle of the sill with the
weep slots to the interior and mark its position
with a pencil line along the interior and exterior
base.
3
Place the two wall jambs [B] into the ends of
the curb [A]. Masking tape may be used to hold
the curb in place during this operation. Plumb the
jambs and mark the hole locations on the wall.
Remove all parts and drill the walls for mounting
hardware.
For tile or marble walls, drill six 3/16" diameter
holes and insert the plastic wall anchors [C].
Attachments to fiberglass or acrylic units can be
made in two ways. If a reinforcement is built into
the wall of unit, drill six 1/8" holes to install
mounting screws directly into the reinforcement.
If walls are not reinforced, drill six 3/16" holes and
install plastic wall anchors or toggle bolts (toggle
bolts not supplied by A
LUMAX).