Manual

EPH-N00-06009
5-20-97
Page 5 of 11
4
6
Measure the wall-to-wall opening at the top
of the wall jambs [B] and cut the header [H] to fit
the exact opening. Using a 3/16" drill bit, drill the
interior face of the header on both ends as shown.
Wipe the shower walls and sill, the curb [A]
and the wall jambs [B] with a clean, dry cloth to
remove any dust or debris. Apply a 1/4" bead of
caulk along the inside of both of the pencil lines
marked in Step #2. Carefully replace the curb in
the exact position marked. Caulk the inside of the
curb ends where they meet the wall.
Replace both wall jambs and attach to the walls
with six #8 x 1 1/2" truss head screws [D].
Place the setting blocks [E] in the curb [A] to
support the fixed glass panel [F]. Position the blocks
3" from each corner of the glass panel. Remove any
protective strips from the glass panel and set it into
place on the setting blocks and approx. 1/2" into the
wall jamb [B]. A strip of masking tape 1/2" from each
vertical edge of the glass will aid alignment.
NOTE: Obscure glass panels should be installed with
the rough surface of the glass to the exterior of the unit.
Deco or etched glass panels should be installed with
the patterned surface to the inside.
Press the 180° post [G] into the curb and position to
overlap the glass panel by 1/2". Use masking tape to
hold the post in position temporarily.
NOTE: To facilitate out of plumb walls, the 1/2" glass
bite may be varied from 1/4" to 3/4".
5