INSTALLATION INSTRUCTIONS BATH ENCLOSURES An Alcoa Company ® Tel: 800-643-1514 Fax: 870-234-3181 www.alumaxbath.com 694 SERIES NEO-ANGLE PIVOT SHOWER ENCLOSURE Copyright © Alumax Bath Enclosures 1996. All rights reserved.
LIMITED WARRANTY AND REMEDY ALUMAX BATH ENCLOSURES warrants to its dealers, customers, and all subsequent purchasers and users, that the products supplied by it shall be free from material defects in material and workmanship for a period of one (1) year after shipment, provided they are installed and maintained according to ALUMAX BATH ENCLOSURE's recommended practices and installation instructions.
Page 3 of 6 EPH-N00-06064 3-8-04 G A. B. C. D. E. A 2 Wall Jambs 2 Side Panels 1 Door Frame 1 Drip Deflector 1 Drip Vinyl F H F. G. H. J. K.
1 The ALUMAX 694 Shower Enclosure is completely reversible and may be installed pivot-left or pivot-right (hinge-left or hinge-right). For maximum waterproofing, the pivot jamb should be opposite the shower head. Using the diagram, determine the correct position for the door in your particular installation. This instruction sheet depicts a pivot-right installation. CAUTION: For safety reasons, the door panel must always open outward. 2 Locate and mark the center of the shower sill.
4 Secure the side panels to the wall jambs with six (6) #6 x 3/8" pan head tek screws. These screws do not require drilling through the wall jambs, however, predrilled pilot holes in the panel rails are provided for guiding the screws. 5 Cut the drip vinyl [E] 1/2" longer than the drip deflector [D] and notch it on each end as shown. Slide the drip vinyl into the deflector and glue or crimp the ends of the vinyl slot.
7 Wipe the shower walls and sill, and shower door assembly with a clean, dry cloth to remove any dust or debris. Apply a 1/4" bead of caulk along the inside of both wall jambs at the wall surface, along the inside of the curb at the shower sill surface, and between the curbs and vertical rails. The Care and Cleaning of your new ALUMAX Bath Enclosure. The simplest and preferred method of cleaning your unit is by washing it with clean water and drying with a soft cloth.
