Instruction Manual

ManualsBrandsAlumax ManualsFor Home790 Towel Bar

EPH-N00-06049

2-28-01

Page 1 of 1

738/790 TOWEL BAR

INSTALLATION INSTRUCTIONS

INSTRUCTIONSINSTRUCTIONS

INSTRUCTIONS

Remove the door panel and lay it flat on a worktable

with the handles accessible. Secure the towel bar base to

the towel bar with the #7 x 1/2" flat head screw. Use alcohol

to thoroughly clean the towel bar pad and cap and the glass

on both sides in the approximate location where the towel

bar will be attached to the glass. Loosen the handle screws

until the exterior handle can be removed. Attach the cap

nut to the exterior of the panel with the lower handle

screws. Loosely thread the upper screw into the towel bar.

Using a carpenter's framing square or tape measure, square

up the towel bar on the door panel. Use a pencil to mark the

towel bar pad's location on the glass (mark must be visible

through the glass).

Remove the towel bar assembly and turn the door

panel over so the interior side is up. Apply a structural

adhesive such as epoxy*

(not supplied)

on the interior face

of the glass in the location marked. Press the towel bar cap

into place and secure it with a strip of masking tape.

Turn the door panel back over so the exterior face is up,

being careful not to move the towel bar cap. Apply adhesive

onto the glass in the marked position. Reattach the towel

bar and handle screw and carefully rotate the towel bar into

position and press it firmly into the adhesive. Use several

strips of masking tape to secure the towel bar. After the

adhesive has cured, reinstall the door panel.

* An optional adhesive kit is available.

Adhesive Kit Part Number: EPH-N00-04375.

PARTS LISTPARTS LIST

PARTS LIST

A.A.

A. 1 Towel Bar Cap

B.B.

B. 1 #7 x 1/2" Flat Head Screw

C.C.

C. 1 Towel Bar Base

D.D.

D. 1 Towel Bar Assemby

E.E.

E. 1 Cap Nut

)