e User guide

ManualsBrandsAlumax ManualsFor HomeDesignLine Hing

Page 1 of 5 EPH-N00-06092

12-9-03

HEAVY GLASS

HINGE

INSTALLATION INSTRUCTIONS

A. 1 Stationary Leaf With Gasket

B. 1 Hinge Leaf With Gasket

C. 1 Back Plate

D. 1 Housing

E. 1 Bushing

F. 2 Nylon Insert

G. 2 Bearing

H. 2 Plastic Piston

I. 2 Spring

J. 2 Set Screw

K. 2 Back Plate Screw

L. 2 Hinge Leaf Screw

M. 4 #10 x 2" Screw

N. 1 Allen Wrench

HINGE PARTS LIST

BATH ENCLOSURES

Te l :

Fax:

800-643-1514

870-234-3181

www.alumaxbath.com

An Alcoa Company ®

Summary of content (5 pages)

PAGE 1
HEAVY GLASS HINGE BATH ENCLOSURES INSTALLATION INSTRUCTIONS An Alcoa Company ® Tel: 800-643-1514 Fax: 870-234-3181 www.alumaxbath.com A F J E C K I H G D F L B M N HINGE PARTS LIST A. B. C. D. E. F. G. H. 1 1 1 1 1 2 2 2 Stationary Leaf With Gasket Hinge Leaf With Gasket Back Plate Housing Bushing Nylon Insert Bearing Plastic Piston Copyright © Alumax Bath Enclosures 2003. All rights reserved. Page 1 of 5 I. J. K. L. M. N.
PAGE 2
LIMITED WARRANTY AND REMEDY ALUMAX BATH ENCLOSURES warrants to its dealers, customers, and all subsequent purchasers and users, that the products supplied by it shall be free from material defects in material and workmanship for a period of one (1) year after shipment, provided they are installed and maintained according to A LUMAX BATH ENCLOSURE's recommended practices and installation instructions.
PAGE 3
1 Note glass cut out dimensions. Double check these dimensions before proceeding. 2 Unscrew the two hinge leaf screws (L) and remove hinge leaf (B). Clean the glass and gasket surfaces with alcohol. (For the gasket to hold properly, the glass and gasket surfaces must be cleaned to remove the sodium dioxide lubricants used in tempering furnaces.) Note that the hinge mounting is a compression fit.
PAGE 4
Check your walls with a straight edge. If the mounting is irregular the hinge may not function properly. Determine the centerline of the door area and mark the curb with a pencil or chalkline. Masking tape may be used on hard-to-mark surfaces such as ceramic tile or marble. Locate and mark a plumb centerline on the wall surface intersecting the centerline on the curb of the opening.
PAGE 5
6 Set panel back on spacers and screw one screw into the hole you drilled on the top hinge. Set your panel plumb with a level. Mark the rest of the holes, remove panel and drill all the holes. Add a small amount of silicone to each hole. You may want to cover the hinge leafs (A and B) and back plate (C) with masking tape to prevent scratching with the screwdriver, drill or drill bit. Set panel back on spacers and screw in all the screws with a screwdriver.