Installation Guide

Configuring System Parameters Access Unit Installation Guide
18 BreezeCOM
6.4 Antenna Diversity Configuration
1. From the main menu, select 1 to access the System Configuration menu.
2. Type 3 to access the Wireless LAN Parameters menu.
3. Type 6 to access the Transmit Diversity sub-menu.
4. Select the Antenna Diversity option: 0 - Use Two Antennas, 1 - Use Antenna
No. 1, or 2 - Use Antenna No. 2.
6.5 Reset Unit
1. Press Esc twice to return to System Configuration menu.
2. Type 5 to access the Station Control sub-menu.
3. Type 1 to access the Reset Unit sub-menu.
4. Type 1 followed by Enter to reset the unit so that new configuration settings
are applied.
Note: Should you make any mistake during configuration, or should you
encounter any problem associated with system configuration parameters,
you may configure the unit back to factory defaults: Select 2 in the
Station Control menu to access the Set Factory Defaults menu and then
Type 1 to load the default values.
Select 1 in the station control menu to access the Reset Unit, then type 1
so that the unit will be reset in order for the factory defaults to take
effect.