User's Manual

BreezeACCESS SU-M Installation Guide
3-2
Configuration Applications
After completing the installation process, as described in the preceding
chapter, the basic parameters must be configured to ensure that the SU-M-
900 operates correctly. Once the basic parameters have been configured,
additional parameters can be remotely configured via the Ethernet port or
the wireless link using Telnet, TFTP or SNMP management.
Parameters can be configured using either of the following alternatives:
Accessing the Monitor Program using
Telnet
Connect a PC to the Ethernet port, using a straight Ethernet cable. Before
running the Telnet program, configure the PC’s IP parameters to enable
connectivity with the unit. The default IP address is 10.0.0.1.
Using BreezeCONFIG ACCESS
Connect a PC to the Ethernet port, using a straight Ethernet cable. Run the
BreezeCONFIG program. You can use the Set IP tool of BreezeCONFIG to
configure the IP parameters (IP Address, Subnet Mask and Default Gateway
Address) based on the unit’s MAC Address, which is marked on the front
panel of the unit.
Refer to BreezeACCESS 900 System Manual for more information on
accessing and using the Monitor program and on configuring parameters.
Refer to the BreezeCONFIG ACCESS User’s Manual for more information on
using BreezeCONFIG for configuring parameters.