User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 370 System Manual
3.3.14 Configuring the SNMP/Trap Manager
This section describes the commands for:
 “Configuring the SNMP Manager” on page 370
 “Configuring the Trap Manager” on page 373
3.3.14.1 Configuring the SNMP Manager
To enable 4Motion configuration over SNMP, you are required to first configure
the SNMP Manager. You can configure up to five SNMP Manager entriess for the
For AU
groups
{ BsDeRegistrationTable |
BsIntegrity |
BsMobilityTable |
BsNetworkEntryTable |
BsTrafficTable |
BsUtilizationTable |
BsIdleModeTable |
BsFastFeedbackCQIHandlingT
able |
BsAckNackChannelHandlingTa
ble |
BsEndTransactionUpdateTabl
e |
BsDlDataZoneFrameHistogram
sTable |
BsTxR1NetTrafficTable |
BsRxR1NetTrafficTable |
BsTxR1TotalTrafficTable |
BsRxR1TotalTrafficTable |
BsDLHARQSbDropsTable |
BsDLHARQTransmissionTable
| BsGeneral |
Bsallmsbasicmode |
Bsspecificmsadvancedmode}
For a
description of
each
parameter in
this
command,
refer to
Table 3-26
Mandatory N/A Refer to
Table 3-26.
Display
Format
<Group Name> <Status>
Command
Modes
Global command mode