User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 478 System Manual
3.8.5.2.4 Configuring R6 Profile Parameters
To configure mapping rules to R6 Profile parameters, run the following command:
npu(config-bs-66053-srvcmaprule-1)# r6prof [datadeliverytype {uGS |
rTVR | nRTVR | bE | eRTVR | any} ] [priority <(-1 to -1 StepSize 1) | (0 to 7
StepSize 1)> ] [mediaflowtype <string (32)> ] [use-mediaflowtype {TRUE | FALSE} ]
[mir <(-1 to -1 StepSize 1) | (0 to 40000 StepSize 1)> ] [cir <(-1 to -1 StepSize 1) |
(0 to 40000 StepSize 1)> ] [latency <(-1 to -1 StepSize 1) | (0 to 5000 StepSize 1)>].
[jitter <(0 to 5000
StepSize 1)> ]
Relevant only if
modify-serviceqos is TRUE
and the datadeliverytype is
uGS or eRTVR. An internal
R1 profile parameter
specifying maximum tolerated
jitter in milliseconds.
Mandatory
when
creating a
new Service
Mapping
Rule.
N/A 0 - 5000
[latency <(0 to
5000 StepSize 1)>
]
Relevant only if
modify-serviceqos is TRUE
and the datadeliverytype is
uGS or eRTVR. An internal
R1 profile parameter
specifying maximum latency
in milliseconds.
Mandatory
when
creating a
new Service
Mapping
Rule.
N/A 0 - 5000
[grant-interval <(0
to 5000 StepSize
1)> ]
Relevant only if
modify-serviceqos is TRUE
and the datadeliverytype is
uGS or eRTVR. An internal
R1 profile parameter
specifying the grant interval in
milliseconds.
Mandatory
when
creating a
new Service
Mapping
Rule.
N/A 0 - 5000
Command
Modes
bs service mapping rule configuration mode
IMPORTANT
Note that when creating a new Service Mapping Rule all mandatory parameters must be
configured, including those that may not be relevant for the Service Mapping Rule.