User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 480 System Manual
3.8.5.3 Restoring Default Values for Service Mapping Rule
Configuration Parameters
After enabling the Service Mapping Rule configuration mode you can restore the
default values for non-mandatory parameters in the following parameters tables:
 R1 Profile (refer to Section 3.8.5.3.1)
 R6 Profile (refer to Section 3.8.5.3.2)
3.8.5.3.1 Restoring the Default Values of RI Profile Parameters
To restore some or all of R1 Profile non-mandatory parameters to their default
values, run the following command:
npu(config-bs-66053-srvcmaprule-1)# no r1prof [modify-serviceqos ]
[dfltpriority ]
[use-mediaflowtyp
e {TRUE | FALSE}
]
If this parameter has a value
TRUE, the service lookup
function will try to match the
R6 media flow type with the
mediaFlowType entry in the
table.
If FALSE the service lookup
function will ignore the R6
media flow type.
Optional FALSE
 TRUE
 FALSE
[mir <(-1 to -1
StepSize 1) | (0 to
40000 StepSize
1)> ]
An R6 parameter entry in the
lookup table specifyingthe
maximum sustained traffic
rate in Kbps. A value of -1
means any.
Optional -1
 -1
 0 - 40000
[cir <(-1 to -1
StepSize 1) | (0 to
40000 StepSize
1)> ]
An R6 parameter entry in the
lookup table specifying the
minimum reserved traffic rate
in Kbps. A value of -1 means
any.
Optional -1
 -1
 0 - 40000
[latency <(-1 to -1
StepSize 1) | (0 to
5000 StepSize 1)>
]
An R6 parameter entry in the
lookup table specifying
tolerated latency in
milliseconds. A value of -1
means any.
Optional -1
 -1
 0 - 5000
Command
Modes
bs service mapping rule configuration mode