User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 481 System Manual
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the dfltpriority to the default
value, run the following command:
npu(config-bs-66053-srvcmaprule-1)# no r1prof dfltpriority
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all R1 Profile non-mandatory parameters to their default value, run the
following command:
npu(config-bs-66053-srvcmaprule-1)# no r1prof
3.8.5.3.2 Restoring the Default Values of R6 Profile Parameters
To restore some or all of R6 Profile parameters to their default values, run the
following command:
npu(config-bs-66053-srvcmaprule-1)# no r6prof [datadeliverytype ]
[priority ] [mediaflowtype ] [use-mediaflowtype] [mir ] [cir ]
[latency ]
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the mir and cir to the default
values, run the following command:
npu(config-bs-66053-srvcmaprule-1)# no r6prof mir cir
These parameter will be restored to their default values, while all other
parameters will remain unchanged.
NOTE
Refer to Section 3.8.5.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# no r1prof [modify-serviceqos ]
[dfltpriority ]
Privilege
Level
10
Command
Modes
bs service mapping rule configuration mode