User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 488 System Manual
3.8.5.6.4 Displaying Configuration Information for Service Mapping Rule R6
Profile Parameters
To display configuration for the R6 Profile parameters of a specific or all Service
Mapping Rules, run the following command:
npu# show srvcmaprule-r6prof bs [<(1 to 16777215 StepSize 1)> rule-index <(1
to 255 StepSize 1)>]
Specify the BS ID and Service Mapping Rule index if you want to display
configuration for a particular Service Mapping Rule. For example, to display the
R6 Profile parameters of Service Mapping Rule 1 in BS 66053, run the following
command:
npu# show srvcmaprule-r6prof bs 66053 rule-index 1
Do not specify these parameters if you want to view configuration information for
all existing Service Mapping Rules. To display information for all Service Mapping
Rules, run the following command:
npu# show srvcmaprule-r6prof bs
rule-index <(1 to 255
StepSize 1)>]
The Service Mapping Rule
index. To be used only if you
want to display the R1 Profile
parameters of a specific
Service Mapping Rule.
Optional N/A 1-255
Display
Format
(for each
existing
Service
Mapping
Rule if
requested
for all
Service
Mapping
Rules)
BSIDLSB :<value>
MappingRuleIndex :<value>
ModifyServiceQoSParameters :<value>
DefaultPriority :<value>
DataDeliveryTypeR1Profile :<value>
PriorityR1Profile :<value>
MIRR1Profile :<value>
CIRR1Profile :<value>
Jitter :<value>
LatencyR1Profile :<value>
GrantInterval :<value>
Command
Modes
Global command mode