User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 499 System Manual
3.8.6.4 Terminating the Power Control Configuration Mode
Run the following command to terminate the Power Control configuration mode:
npu(config-bs-66053-pwrctrl)# exit
3.8.6.5 Displaying Configuration Information for Power Control
Parameters
You can display the current configuration information for the following
parameters tables:
 Noise and Interference Level (refer to Section 3.8.6.5.1)
 Maximum EIRxP (refer to Section 3.8.6.5.2)
 Required C/N Level (refer to Section 3.8.6.5.3)
 All (refer to Section 3.8.6.5.4)
3.8.6.5.1 Displaying Configuration Information for Power Control Target Noise
and Interference Level Parameters
To display configuration for the Power Control Target Noise and Interference Level
parameters, run the following command:
npu# show pwrctrl-nilevels bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Power Control Target Noise and Interference Level
parameters of BS 66053, run the following command:
npu# show pwrctrl-nilevels bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
Command
Syntax
npu(config-bs-66053-pwrctrl)# exit
Privilege
Level
10
Command
Modes
bs power control configuration mode